What To Do If There Is An Unreadable Language On The Logon Screen That Will Probably Not Accept Your Username And Password? Is There Any Bypass Or Just A Removing Technique?

Asked 08-Oct-2018
Viewed 299 times
Ask Question

0

 What To Do If There Is An Unreadable Language On The Logon Screen That Will Probably Not Accept Your Username And Password? Is There Any Bypass Or Just A Removing Technique?


    Anonymous User
    asked by Anonymous User in troubleshooting
    Answer Add comment

    1 Answer

    0

    If you are experiencing the problems listed above, proceed to the following steps:
    • Start the device and press the 'F8' key when Windows boots up. After that, in the command prompt, type 'Safe Mode' and press enter. If you do not specify a password, the default password will be blank. Then, in reality, you'll enter the doc command as follows:
    • There, enter 'net user net consumer xxx 123456 /add' (xxx is the call of the locked account, and 123456 is the new password for the new account). After all of this, the command will be completed successfully.
    • Please keep in mind that the suggestions above can be useful if the Administration password isn't always set.

    However, if the password has already been set, you must proceed as follows:

    To begin, the system must be burned to a USB flash drive in order to remove the forgotten or misplaced password from your Windows operating system.

    Prepare a USB flash drive in addition to your laptop.

    Then, using the USB flash drive that you initially burned, recover the forgotten or lost Windows password.

    You can look for the 'Windows Password Recovery Enhance' for more information.


    Read More:

    Add comment
    Hitesh Vohra
    answered 28-May-2022 by Hitesh Vohra